Interface 1 or external DivMMC

A list of everything you need to know. Maybe...
User avatar
mitja_i
Posts: 368
Joined: Tue May 30, 2017 6:27 am
Location: Ljubljana, Slovenia
Contact:

Interface 1 or external DivMMC

Postby mitja_i » Tue Feb 18, 2020 6:53 pm

By Tim Gilberts on FB:
To use these type of devices it is necessary to disable the onboard SD card interface and the onboard DivMMC system as they use the same ports. These devices also rely on an original 48K/128K ROM so from a 48K or 128K machine identity:
OUT 9275,135: OUT 9531,246
OUT 9275,128: OUT 9531,8
soft reset
Again it is best to use the Next RESET button not the one on the DivMMCdevice. You can however, use either the NMI on the device or the DRIVE (green) button on the Next - they are the same.

I would strongly recommend though that you ensure the felts are replaced - the use of carts that have not been will usually wreck the cartridge and may dirty the drive mechanism. When you look at the cart - gently hold it level and poke the felt with the end of a pencil - it will fall apart usually.
Backer 423 @ 37% funded, 10th hour. Base version. Shipping nr. 533. Received February 19, 2020.
Backer 1027 @ 141% funded, 10th minute.

Original 48K (issue 4b) with IF1, two microdrives and vDrive.
---
ZX Spectrum Next glossary

Who is online

Users browsing this forum: No registered users and 2 guests