I am using VGA and I get no picture

A list of everything you need to know. Maybe...
User avatar
mitja_i
Posts: 368
Joined: Tue May 30, 2017 6:27 am
Location: Ljubljana, Slovenia
Contact:

I am using VGA and I get no picture

Postby mitja_i » Thu Feb 20, 2020 5:37 pm

When the Next boots hold down V for VGA – Mode 0-6 50hz / 60hz can be selected. VGA0 is the preferred mode as this has accurate timings. 1 – 6 are also accurate timings but increase slightly in speed. N works as above but there are 12 possible configurations you can choose from. You'll start at VGA0@50Hz, next one will be the same at 60Hz and so forth. ENTER again selects and saves the changes. Audio is also being produced during the VGA Test Screen phase, however you will need powered speakers (or earphones) plugged in the audio out connector at the back of your Next.
Figure02-TestScreenMode7.png
Figure02-TestScreenMode7.png (62.09 KiB) Viewed 1699 times
Backer 423 @ 37% funded, 10th hour. Base version. Shipping nr. 533. Received February 19, 2020.
Backer 1027 @ 141% funded, 10th minute.

Original 48K (issue 4b) with IF1, two microdrives and vDrive.
---
ZX Spectrum Next glossary

Who is online

Users browsing this forum: No registered users and 2 guests