I have a Grey ZX Spectrum+2 128k. I have the original power supply and the system is powering on ok with the tape deck fully functional. I am however having a problem getting it to display on a TV. The aerial cable does not seem to be getting detected on my TV,
but I put this down to an issue with it being a modern TV. I then purchased an RGB to SCART cable that is designed for the exact model I have however what I am getting when I plug it in is what can be seen in the image below.
There is something there but I cannot get it to display properly. Can anyone offer any advice where I am going wrong?
Everything that is not ZX Spectrum Next goes here. Get ready for the Nostalgia!
3 posts • Page 1 of 1
The image hasn't embedded properly in your post
You may want to post over the WOS, there is a lot of the same people on both forums but you might get some more hardware focussed expertise over there.
Who is online
Users browsing this forum: No registered users and 2 guests